MobilSat MSP-C Manuel d'utilisateur télécharger pdf (Page 12)

Isolation then setting Isolation Optimization to low should offer a minimal

acceptable isolation for TX use.

Medium

When set to Medium, CrossPol is initially set similar to the Low setting.

After the D3 completes Signal Peak it will begin a Hughes ACP if in

HughesNet mode. If in any other Satellite System mode the D3 will begin

a MotoSAT passive CrossPol to optimize the RX polarization. This

CrossPol typically set TX Isolation also.

High

When set to High, initializes like Medium. When in HughesNet mode the

ACP routine will maximize Hughes Isolation to maximum value.

Transmitter Offset (0)

Transmitter Offset works in conjunction with Isolation Optimization.

When Isolation Optimization is set to Medium or High. Once the D3 has

finalized ACP, test the CrossPol with the NOC and adjust Skew as

necessary. Note the difference of Skew change and put this value into the

Transmitter Offset box. (Value in +/-degrees)

Important: This feature does not work in Hughes Net Mode.

Use Last Known Position (Disabled)

Disabled (Default)

When Use Last Known Position is disabled the D3 reads the current

location values (Latitude and Longitude) from the GPS and begins a new

search from this location when “Search” has been initiated.

Enabled

When Enabled the D3 Controller will return the Dish to the last known

location a “Search” has been initiated.

If the Target Satellite is not found then the Dish will begin a normal search

routine.

Azimuth Search Window (10)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

MobilSat MSP-C Manuel d'utilisateur Page 12