MobilSat MSP-C Manuel d'utilisateur télécharger pdf (Page 10)

Other Modems currently displayed in the Satellite System drop down box

are; UnaSAT, Aloha, and Generic. These currently function in Generic

mode.

Important Note: It is extremely important that when using HughesNet

mode that many of the following configurations are set correctly. Just

being close will not work.

Satellite Longitude (89W)

Satellite Longitude is a numerical value that sets the Target Satellite

Location. I.E. 89W

If inputting a Satellite Longitude in the western hemisphere then you

would place a W after the numerical longitude value. It is not necessary to

add the W as the western hemisphere is set to default.

If inputting a Satellite Longitude in the eastern hemisphere then you

would place a E after the numerical longitude value.

IF Frequency (1430)

HughesNet Required! This value is set from 950 to 1450 MHz. Check

with the Hughes configurations to insure accuracy.

For all other Modems including Generic this value is not necessary.

RX Polarization (V)

This is a critical setting. For the D3 to set the Satellite System properly

for correct modem operation the Receive Polarization must be correct.

TX Polarization (H)

HughesNet Required! Sets the TX Polarization value for Hughes. Not

required for all other systems. Check with the Hughes configurations to

insure accuracy.

Note: When using the DataStorm F1 Mount TX Polarization must be

Horizontal Only! When using F2, F3, XF2, and XF3 mounts the TX

Polarization must be set to the opposite field of the RX Polarization.

Symbol Rate (30)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

MobilSat MSP-C Manuel d'utilisateur Page 10