MobilSat MSP-C Manuel d'utilisateur télécharger pdf (Page 9)

Default to 255.255.255.0, see your IT manager if changes to this value are

necessary.

Modem Gateway (192.168.0.1)

This value is set to the modem address. See manuals or white papers for

more information.

Router Gateway (192.168.0.1)

This value is set to the Router address. If a LAN switch is used then

setting this to the modem address is typical. See manuals or white papers

for more information.

DNS Address (192.168.0.1)

This value is set to the modem address. See manuals or white papers for

more information.

Startup Delay ( 0 )

Startup Delay sets a time delay from D3 Power On to active LAN

connection. This time period is displayed in seconds (0 to 999). This time

delay is used to allow the Router and or Modem time to configure

properly and communicate after AC power has been applied to these

devices. The D3 will attempt to communicate with the modem after the

delay time has expired.

Example; a Linksys router typically requires 20 seconds before it has set

DHCP and accessed the WAN port before it is ready. So setting the

Startup Delay to 30 seconds should resolve this for the D3 to see the

modem. Network Switches do not require a delay.

Satellite System (Generic)

Satellite System sets Modem or ISP type. Setting this value for the proper

modem type will allow the D3 to integrate at different levels with specific

modems.

Currently the D3 integrates closely with the HughesNet and iDirect

Modems allowing the D3 to confirm correct Satellite Identification, Signal

Quality level, set TX ranging values, etc. The D3 may soon integrate with

other Modem suppliers.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Pas de commentaire

MobilSat MSP-C Manuel d'utilisateur Page 9